[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: All zones showing fault (NX-8E), please help

Subject: Re: All zones showing fault (NX-8E), please help
From: MaxMaxwell <nosp@xxxxxx>
Date: Sun, 13 May 2007 23:32:38 -0400
Newsgroups: comp.home.automation
References: <1179110732.495555.90240@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>

NeonTide wrote:
> Hi all!  I have a Caddx NX-8E with NX-216E Zone Expansion module and
> two NX-148E keypads.  I have programed the system using the DL900
> software, but every zone (21 of them) are showing fault.  I'm not sure
> if I've missed something in the setup or what.  Any thoughts/
> suggestions would be greatly appreciated.  I have put EOL Resistors on
> all unused zones and have turned off box tampering as well.
>
if you have a closed loop and eol in series on every zone you should be ok

References:
- All zones showing fault (NX-8E), please help
  - From: NeonTide

Prev by Message: Re: Water heater eating X-10 signal
Next by Message: Re: Fluorescent Bulbs Are Known to Zap Domestic Tranquillity; Energy-Savers a Turnoff for Wives
Previous by thread: All zones showing fault (NX-8E), please help
Next by thread: Re: All zones showing fault (NX-8E), please help
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home