Re: Control occupancy sensor/motion sensor using Powerlinc V2 controller

[nobody@xxxxxxxxxxxx (Dave Houston)]

arnie <parvezat6@xxxxxxxxxxxxxx> wrote:

>On Jul 21, 3:47 pm, nob...@xxxxxxxxxxxx (Dave Houston) wrote:
>> arnie <parvez...@xxxxxxxxxxxxxx> wrote:
>> >Dave
>> >Can you tell me the link for the programming instructions that you
>> >have referenced so that I can read and understand. My biggest problem
>> >is that I am using an intermediate [that you can say communicator] to
>> >communicate with PLC which in turn sends the commands to the concerned
>> >devices. The intermediate is Smarthome Device Manager [SDM3] so I was
>> >left with the features available from this. This means I am not
>> >directly communicating with PLC. Basically my project is in C# 2005.
>> >Thanks
>> >Arnie
>>
>> I gave you the link earlier in this thread.
>>
>>      http://www.x10pro.com/pro/pdf/pms02.pdf
>>
>> I'll repeat one more time that there is no way to send commands to the
>> motion sensors as they have neither an RF receiver nor a powerline
>> interface.
>Just one more addition to this query:-Do it also requires knowledge of
>the micro controllers/micro processors as well?
>Thanks
>Arnie

Not to understand how the devices function - only if you want to delve
deeper and make your own devices or modify existing devices. Anand has done
some of this because X-10 hardware is not readily available in your country.