Re: Accepting inputs VIA PC

["Robert L Bass" <robertbass1@xxxxxxxxxxx>]

>I am new to HA and I tried searching but here is what I would like to
> do:
>
> I have a lot of parts from access and security systems. I would like to
> create or use some software and hardware that will allow me to monitor
> these NO or NC circuts VIA my PC.
>
> I have a controller built that will create outputs VIA the parallel
> port... but I would like to have inputs as well. Is there any prefab
> hardware and software that will allow me to do this?

Napco's P9600 alarm control panel can be connected to a PC using their RS232 kit.  The system reports sensor changes (open, close,
short) as well as system status changes (arm, disarm, alarm, bypass, etc.) in real time.

--

Regards,
Robert L Bass

=============================>
Bass Home Electronics
941-866-1100
4883 Fallcrest Circle
Sarasota · Florida · 34233
http://www.bassburglaralarms.com
=============================>