Re: Stanley Garge Door Status Indicator

["BruceR" <razrbruce@xxxxxxxxxxxxxxx>]

No, I have the one you're talking about.  I'm thinking that there must
be a module similar to the 30001 embedded in his old opener.

 Dave Houston wrote:
> Bruce,
>
> Are you talking about the 3040 unit he has?
>
> With the 30001, 30003 the door sensors sent RF that used the security
> protocol but the 30001 transceiver then sent extended PLC codes to
> the 30003 indicator.
>
> I listed all the codes in a page on my old web site. If my new domain
> ever gets activated I'll publish some of those pages again.
>
> "BruceR" <razrbruce@xxxxxxxxxxxxxxx> wrote:
>
>> The codes sent by the garage door sensors are the same type as used
>> by the X10 security System.  In fact, I only had one garage door
>> sensor so I used an X10 door/window sensor with a mercury switch for
>> the other door.
>>
>> Brian Allston wrote:
>>> I had an older Stanley LightMaker grarge door opener.  The gear
>>> casing cracked so I have replaced it with new a Genie opener but I
>>> would like to restore the functionality of the Stanley garage door
>>> status indicator.  I figure that I can do this with some normally
>>> open reed switches, a Powerflash module and some macro sequences.
>>> The Stanley door status indicator (model # 3040) has three LED
>>> indicators.  The LEDs are green red and yellow.
>>> - green on = door closed
>>> - red on = door open
>>> - red blink = door obstructed
>>> - yellow on = door secured
>>>
>>> I have the house code set to "G" and I know that the door opener
>>> controller head transmitted a standard "G1 ON" and "G1 OFF" to
>>> control a lamp module. However, it sent non-standard message to "G2"
>>> and "G3" for controlling the status indicator.  I assume that this
>>> is some form of extended data.
>>>
>>> Can anyone provide the message info for controlling the status
>>> indicator? Any info is greatly appreciated.
>>
>
>
> http://www.davehouston.net
> http://tech.groups.yahoo.com/group/roZetta/
> roZetta-subscribe@xxxxxxxxxxxxxxx