Re: Question of the day

["ABLE_1" <royboynospam@xxxxxxxxxxxxx>]

Thanks for the info Jeff.  That is what I expected but just wanted to
confirm.

Les




> We have two panels, but one panel just carries major loads like the A/C
> compressors, stove, & dryer.  Most branch circuits come into the other
> panel, and one signal bridge would normally be installed there.  However,
> we
> don't even need one because all X10 circuits are wired into the same
> phase.
>
> Even if your X10 loads are distributed across both panels, you may still
> be
> able to get away with one signal bridge if the run between the two panels
> is
> not too long.  If your two panels are at opposite ends of a large house,
> and
> equally share X10 loads, then you probably should install bridges at each
> one.
>
> Jeff
>
>