[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Short Plenum Run Question

Subject: Re: Short Plenum Run Question
From: robertlbass@xxxxxxxxxxx
Date: 29 Nov 2005 01:06:59 -0800
Newsgroups: comp.home.automation
References: <1132603427.327439.43220@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> <lsd6o1hqf50jj4fk31vbifep8ftmlkknf2@xxxxxxx> <1132674666.798264.215530@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> <1132981079.336278.73430@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> <cZShf.627948$tl2.121889@pd7tw3no>

> In addition to Robert's coments, building codes may allow you to run
standard FT-4 as well (for communications and network)...

NOT in a duct.  This is a duct -- not a plenum -- and US code does not
permit any cables within it except those necessary to operate the duct.

> In Vancouver (for instance) you don't need to run plenum
> rated wire in a plenum if the total length of the wire run
> (from panel to device) doesn't exceed 9 meters...

Same here although the distance isn't the same, but that rule does not
apply to ducts.

Regards,
Robert L Bass
www.BassBurglarAlarms.com

Follow-Ups:
- Re: Short Plenum Run Question
  - From: L . M . Rappaport

References:
- Short Plenum Run Question
  - From: scary_penguin
- Re: Short Plenum Run Question
  - From: L . M . Rappaport
- Re: Short Plenum Run Question
  - From: Theron
- Re: Short Plenum Run Question
  - From: robertlbass
- Re: Short Plenum Run Question
  - From: Frank Olson

Prev by Message: Re: mystery signal
Next by Message: Re: backbone for structured wiring
Previous by thread: Re: Short Plenum Run Question
Next by thread: Re: Short Plenum Run Question
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home