[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: implementing a toggle function in x10

Subject: Re: implementing a toggle function in x10
From: "Mark Thomas" <mrt@xxxxxxxxxxxxxx>
Date: 3 May 2005 09:47:05 -0700
Newsgroups: comp.home.automation
References: <1115102598.780929.199910@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>

> I haven't been able to find much detail on the Homelink, but I
suspect
> the buttons are only capable of sending a single code.
>
> Obviously if I dedicated a PC I could store a state and write a
"macro"
> that alternates, but that's not really an option for me.

Is a low-cost controller an option? For $150 you can get an Ocelot,
which would allow you to set up your toggle, and as a bonus it would be
able to do many, many other things as well.

- Mark.

Follow-Ups:
- Re: implementing a toggle function in x10
  - From: Dave Houston

References:
- implementing a toggle function in x10
  - From: bcboy

Prev by Message: Re: The G Morgan show (was: MM & Jiminex...)
Next by Message: Re: Need some antenna advice (for my CM15A, of course)
Previous by thread: implementing a toggle function in x10
Next by thread: Re: implementing a toggle function in x10
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home