[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Thermostat recommendations?

Subject: Re: Thermostat recommendations?
From: George Pontis <gpontis@xxxxxxxxxxx>
Date: Sat, 25 Jun 2005 10:01:26 -0700
Newsgroups: comp.home.automation
References: <ebkcb1hniv7qrqmm5ha71hkeulbhtjns4b@xxxxxxx> <1119327997.552820.156120@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> <639fb1tjqan9hst87690b4tbp7qqgjl3re@xxxxxxx>

In article <639fb1tjqan9hst87690b4tbp7qqgjl3re@xxxxxxx>, plettb@xxxxxxxxxxx
says...
> Thank-you VERY MUCH for your post!  It really was a very helpful
> start.

In addition to the other issues, you also need to get power from the furnace to
run the HAI thermostat. The power drain is very low and most furnaces can do it
easily, but I believe that you need at least a three conductor cable from the
furnace to the Tstat. If you have an old system with 2 wire cable it will not be
adequate. You might be able to pull a new wire from the new Tstat to the furnace.
Check the HAI site for installation info on these models for further info.

References:
- Thermostat recommendations?
  - From: Bradley Plett
- Re: Thermostat recommendations?
  - From: mcbill20
- Re: Thermostat recommendations?
  - From: Bradley Plett

Prev by Message: Re: New HA product development
Next by Message: Re: 3 broken WS12As?
Previous by thread: Re: Thermostat recommendations?
Next by thread: Re: Thermostat recommendations?
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home