Re: Vista 20 not dialing out

[NickMark <nmarkowitz@xxxxxxxxx>]

On Saturday, June 15, 2013 6:12:01 PM UTC-4, John Sowden wrote:
> I am reprogramming an Ademco Vista 20 (not a P or SE).  I have not
>
> defaulted the control.
>
> I have programmed in the phone number, format (7-contact id), account
>
> code (0123), placed 10 in the first pair of boxes in the *56 zone
>
> programming section for each zone.
>
>
>
> Problem: when the system is tripped (Keypad * + #), hard wire zone panic
>
> (type 06) or a burg zone, the system does not send a signal.  With a
>
> telco handset placed on the brown/gray telco pair I get dial tone
>
> immediate after tripping the panics (no delay).  This means no line
>
> seizure.  Telco handset on red/green gives me dial tone (no attempt to
>
> dial).  Of course no signal or call at the CS.
>
>
>
> Help?

if its version 1 it does not do contact id higher version do also check to make sure you have phone pairs wired correct  that panels too ald to get tech support on but sounds like you have it programmed correct.