[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Re: New installation. Help needed.
Injun Ear wrote:
> OK, here's my setup. I posted here back in Feb when I was buying my
> new Vista 20P setup. I started installing it today. Got the whole
> thing in and hooked up. I have a 6160 keypad and a 6150 by the back
> door. Got both of them addressed and working.
>
> I have the 2-wire smoke det on zone 1
> 1 motion detector on zone 2 with a resistor across it at the detector
> terminals
> 1 motion det on zone 3 same setup
> Front door mag switch on zone 4 with the resistor in the panel
> Back door mag switch on zone 5 with the resistor in the panel
> Window switch on zone 6, resistor in panel
> garage door switch on zone 7, resistor in panel
> zone 8 not being used, has a resistor in the panel
>
> The whole thing powers up, but I get a fault 2, fault 3, fault 4 and
> fault 6 in the screen on the 6160. I can't figure why. The motion
> detector's LEDs light up when I walk thru the room. The smoke
> detector's green light is flashing every 5 seconds.
>
> The 6150 is displaying 02, 03, 04, 06, FC and "not ready"
>
> I have 2 wave2s connected, one in the garage and one in the hall. Both
> work fine.
>
> I put the resistor across the 2 wires in the smoke detector. Is that
> where it goes? The instructions are vague, look like they want me to
> run 2 smoke detectors, but I only have 1.
>
> Any help would be greatly appreciated. I'm about ready to get hooked
> up with a monitoring company now.
Sounds like your smoke is wired ok, but the resistors need to go in series
with the devices on burg zones, not in parallel.
--
js
Democracy is two wolves and a sheep deciding what to eat for lunch.
Liberty is a well-armed sheep contesting the vote.
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home