Re: Zone Response Times (50ms or 750ms) for GEM-P816

[HandymanYP <yeahprolly@xxxxxxx>]

Thanks Robert. It's not only a single sensor - it has happened with
each sensor at least once on zones 9 through 12.but never with the
sensors on any other zones (same sensors with same wireless
configuration but on zones 1-8). Also, problematic sensors have been
replaced more than once even though they successfully test to be
within manufacturer specifications (13 ohms nominal resistance, 24
ohms maximum resistance, 1 megaohm minimum resistance to trigger an
alarm).

Any other ideas on what could be causing this problem? It's making my
alarm frustrating and almost worthless. Are the end-of-line resistors
different for zones 9-12 on the P816 panel or anything else that makes
these zones different and consequently prone to false alarms?