Re: ADT Galaxy keypad

["SantaUK" <santa@xxxxxxxxxxxxx>]

Do you have it on PDF format?  If you could email me it I would really
appreciate it.  I have a 504 ADT board, and would be installing this for my
friend.

santaukREMOVETHIS@xxxxxxxxxxxxx


"Matthew Brough" <matthew.brough@xxxxxxxxxxxxxxxxxxx> wrote in message
news:WYqdnV-pIIdq2UHanZ2dnUVZ8tSdnZ2d@xxxxxxxxxxxxxxxxx
>I have a copy of the ADT manual. This feature is restricted to their
>version of the software i'm afraid.
>
> "JoeRaisin" <joeraisin@xxxxxxxxxxx> wrote in message
> news:anTCj.172$YD6.50@xxxxxxxxxxxxxxx
>> Frank Olson wrote:
>>> SantaUK wrote:
>>>> Hehehe, no its not that.  I think that the ADT panel has special
>>>> software to enable this function, and I don't have an ADT version of
>>>> the manual, only the original manufacturer version.  Unfortunately the
>>>> keypad only has output number *99 - so no joy on that score.  And I
>>>> can't seem to see anything where you can press * and a number, either
>>>> together or separately, in the manual.
>>>
>>> *99 will exit programming.  In most Ademco panels, pressing * and #
>>> within sixty seconds of power up will get you into programming.  If
>>> "lockout" has been enabled, this won't work though.
>>
>> It sounds like its similar to Ademco (at least the zone numbers line up).
>>
>> The 95, 96 and 99 aren't programmed at the keypad, they are turned on in
>> zone programming.  Once they are on the panel should recognize the
>> commands input at the keypad.
>
>