Re: ADT Galaxy keypad

["Matthew Brough" <matthew.brough@xxxxxxxxxxxxxxxxxxxx>]

If you have a 504 it won't work. It was only ever intended to work on the
ADT software for the Galaxy 8+ & 16+ in the UK. In all honesty the 8+ was
just a 16+ board with the ability to add a rio removed especially for ADTs
smaller installs.
They keypads with the coloured buttons had a separate part number to the
normal MK7 keypad, but the only difference is the colouring of the buttons.
The PCB is exactly the same so if you had a normal MK7 keypad on a 16+ with
ADT software, if you pressed *2,5 or 8 it would have the desired effect.

"SantaUK" <santa@xxxxxxxxxxxxx> wrote in message
news:01d92bf4$0$5516$c3e8da3@xxxxxxxxxxxxxxxxxxxx
> Do you have it on PDF format?  If you could email me it I would really
> appreciate it.  I have a 504 ADT board, and would be installing this for
> my friend.
>
> santaukREMOVETHIS@xxxxxxxxxxxxx
>
>
> "Matthew Brough" <matthew.brough@xxxxxxxxxxxxxxxxxxx> wrote in message
> news:WYqdnV-pIIdq2UHanZ2dnUVZ8tSdnZ2d@xxxxxxxxxxxxxxxxx
>>I have a copy of the ADT manual. This feature is restricted to their
>>version of the software i'm afraid.
>>
>> "JoeRaisin" <joeraisin@xxxxxxxxxxx> wrote in message
>> news:anTCj.172$YD6.50@xxxxxxxxxxxxxxx
>>> Frank Olson wrote:
>>>> SantaUK wrote:
>>>>> Hehehe, no its not that.  I think that the ADT panel has special
>>>>> software to enable this function, and I don't have an ADT version of
>>>>> the manual, only the original manufacturer version.  Unfortunately the
>>>>> keypad only has output number *99 - so no joy on that score.  And I
>>>>> can't seem to see anything where you can press * and a number, either
>>>>> together or separately, in the manual.
>>>>
>>>> *99 will exit programming.  In most Ademco panels, pressing * and #
>>>> within sixty seconds of power up will get you into programming.  If
>>>> "lockout" has been enabled, this won't work though.
>>>
>>> It sounds like its similar to Ademco (at least the zone numbers line
>>> up).
>>>
>>> The 95, 96 and 99 aren't programmed at the keypad, they are turned on in
>>> zone programming.  Once they are on the panel should recognize the
>>> commands input at the keypad.
>>
>>
>
>