Re: ADT Galaxy keypad

["Matthew Brough" <matthew.brough@xxxxxxxxxxxxxxxxxxx>]

I have a copy of the ADT manual. This feature is restricted to their version
of the software i'm afraid.

"JoeRaisin" <joeraisin@xxxxxxxxxxx> wrote in message
news:anTCj.172$YD6.50@xxxxxxxxxxxxxxx
> Frank Olson wrote:
>> SantaUK wrote:
>>> Hehehe, no its not that.  I think that the ADT panel has special
>>> software to enable this function, and I don't have an ADT version of the
>>> manual, only the original manufacturer version.  Unfortunately the
>>> keypad only has output number *99 - so no joy on that score.  And I
>>> can't seem to see anything where you can press * and a number, either
>>> together or separately, in the manual.
>>
>> *99 will exit programming.  In most Ademco panels, pressing * and #
>> within sixty seconds of power up will get you into programming.  If
>> "lockout" has been enabled, this won't work though.
>
> It sounds like its similar to Ademco (at least the zone numbers line up).
>
> The 95, 96 and 99 aren't programmed at the keypad, they are turned on in
> zone programming.  Once they are on the panel should recognize the
> commands input at the keypad.