Re: How to connect window sensors?

[Jim <alarminex@xxxxxxx>]

On Oct 9, 9:11?am, "Bill" <billnomailnosp...@xxxxxxxxx> wrote:
> You can get a long drill bit (like 5 ft.) which has a hole in one end in the
> electrical department of home improvement stores, electrical supplies, etc.
> Then drill up from the window opening into the attic. or drill down from the
> window opening to the baseboard.
>
> So the hole drilled is inside where the window opens.
>
> Then pull a wire through the hole (using hole in drill bit to attach wire),
> then solder on wires as you did and use electrical tape or whatever.
>
> Then squirt silicone into the hole and gently push sensor back into the hole
> so it is flush with the window opening surface. Then glue magnet to window
> or drill hole in window wood and stick magnet in hole.
>
> Stick dirt and dead flies over sensor before silicone dries. Then you have a
> sensor on that window and no wires or contacts visible!
>
> We spent two weeks doing this to a guys house who went out of town while we
> were doing the work. He came back, called the office and was pissed! He was
> really ticked we did not install his system like we said we would. We said
> we did install it! He did not believe us. We had to go out and put a beeper
> on and open/close each window to prove it was installed. And we pointed to
> where the contacts were. He said "I don't see anything!" We said well that
> is what you paid for....


Where do you buy your dead flies?