Re: Napco Gemini P9600 - User code/area problem....

["Just Looking" <nospam@xxxxxxxxxx>]

It should be simple to fix.
If you are using Quickloader for Windows the second Icon (counting left to
right) should have the zone information. Clicking on that Icon you should
see (again counting left to right) Description, Zone Type, Adv. Code, Code,
Area. All zones should be in Area 1 so the entire column should have a 1
under Area.
The eighth Icon (with 2 people on it) should bring up User Asignment. Click
on that Icon and (again counting left to right) Description, Code, AL, Code
Type, IO BV, UP,BE,OV, then AREA. The entire column should have a 1 under
Area.
Do a Full download (not just differences and then restart the panel (with
panel control).



<rdrake75@xxxxxxxxx> wrote in message
news:1178839718.528475.320350@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> I'm setting up my second Napco Gemini P9600 system and running into a
> very strange problem with the user codes: no matter what I do, when I
> try to arm the system it tells me "CODE DENIED. INCORRECT AREA".
>
> The problem is.. I only have 1 Area and I've checked 200 times that
> the user codes, zones, and keypads are all in Area 1.  I've tried
> wiping the system and starting from scratch, tried blanking all the
> user codes via Quickloader and rebuilding them.  Nothing helps..  I've
> verified the area configurations via direct address programming just
> to be sure on the keypad. It's all looks fine.
>
> I never had this problem with my other P9600 system from a few years
> back... They just worked..   Could it be a bad firmware? I've got V60A
> in this new panel.  Everything else works fine..
>
> Thanks for any insight,
> Rob D.
>