Re: Power 632 and Motion

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

You'll not get an accurate resistance reading measuring it with the motion
relay wires connected to the panel..remove them and read it from the wires.


"Bob Smith" <bob@xxxxxxx> wrote in message
news:460d12d2$0$28131$4c368faf@xxxxxxxxxxxxxxxxx
|I have beating my head againts the wall trying to figure this out.  I have
a
| Power632 and a DSC Pet Immune PIR hooked up to Zone 2.
|
| I have zone 2 set to zone type [04] which is said to be an interior in the
| manual.  When I put a ohm meter up to the common and zone 2 pins on the
| alarm witht he motion hooked u I get .00 with the meter set to 200 ohms
and
| then when someone walks in front of it the ohm meter spikes.  This tells
me
| the motion sensor is working correctly as a closed circuit.  The problem
is
| that the alarm panel says that zone 2 is open all the time, no mater if
the
| motion sensor is on or off.  If I short out zone 2 with the commom with a
| resistor it shows on the panel that the zone is closed.
|
| What am I missing here?
|
| Thanks!
|