Re: Ademco Lynx (Rev. 10)

["Mark Leuck" <m..leuck@xxxxxxxxx>]

Only on the SecurityLink version of the Vista-1

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:46944ab9$0$509$815e3792@xxxxxxxxxxxxxxxxx
> 7 minutes?...thought it was 3.5 then 3.5 for a TOTAL of 7
>
> --
>
> Rob
> Microsoft MVP - FrontPage
>
>
>
>
>
> "Buggs" <thatsallfolksl@xxxxxxxxx> wrote in message
> news:NBXki.102941$s57.86448@xxxxxxxxxxxxxxx
> | Mark Leuck wrote:
> | > "Another Anonymous" <anon.mail@xxxxxxxxxxxxx> wrote in message
> | > news:ZqUki.7889$bz7.6637@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> | >> I have an ademco lynx, it reports to my alpha pager (motorola
> | >> advisor elite) via numeric at this time. I was told that it may
> | >> support alpha numeric paging that I need to get the modem access
> | >> number to my pager (which i've done) and program it to do so. I
> | >> looked into the programming of my panel using compass and I'm not
> | >> sure if it actually does support alpla numeric paging or which
> | >> setting to use if so (i.e. contact id report, ademco low speed,
> | >> etc.) any help much appreciated.
> | >
> | > It doesn't
> |
> | Sure it does, Mark. Just go into programming section 109 and enter the
> | "change format" code. I believe it's 8888. Then power down, wait exactly
> | seven minutes, and power up with the battery only. Wait another seven
> | minutes and connect AC, but you have to connect both legs at exactly the
> | same time. Remember, just like the old Vista 1 series.
> | js
> |
> |
>
>