Re: RFI and DSC systems

["Bob La Londe" <nospam@xxxxxxxxx>]

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:468bc1b8$0$497$815e3792@xxxxxxxxxxxxxxxxx
> ot... hot enough for ya?
> sheesh...my pool water is 92f this morning!

The water temp in the river was hoverng around 80 last weekend.  I may go do
a little fishing today.


>
>
> "Bob La Londe" <nospam@xxxxxxxxx> wrote in message
> news:468bb469$0$16402$88260bb3@xxxxxxxxxxxxxxxxxxxx
> |
> | "Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
> | news:468ba7e0$0$502$815e3792@xxxxxxxxxxxxxxxxx
> | > Not that familiar with DSC, but if the panic fire is from the
> keypad..have
> | > you hardened the keypad run?
> | > Ground only one side of the shield...but you would know that being a
> ham.
> | >
> |
> | And all grounds go to the same point.
> |
> |
> | >
> | >
> | >
> | >
> | > "MikeSus" <mikesus@xxxxxxxxx> wrote in message
> | > news:1183549011.863308.169320@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> | > | Has anyone hardened a DSC System against RFI?  I am an amateur radio
> | > | operator and had a problem on almost all frequencies until I put in
> .
> | > | 001 mfd caps on each loop, and put a snap on choke around the
> hardwire
> | > | lines.  Now the only problem is when I transmit on 80m (3.700Mhz)
> | > | After a short while of transmitting, I get an expansion module
> failure
> | > | message and then a panic fire.  I do have the wireless Fire Alarm
> and
> | > | thought it could be gating, but that would not explain the expansion
> | > | module failure message.  Any ideas?
> | > |
> | >
> | >
> |
> |
> |
> | --
> | Posted via a free Usenet account from http://www.teranews.com
> |
>
>



--
Posted via a free Usenet account from http://www.teranews.com