Re: FBII OMNI 400/600 question

["hayes" <h@xxxx>]

"Security Alarm Man" <Sec.Alarm.Man@xxxxxxxxx> wrote in message
news:1177469347.337302.6830@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> This is a battery protection circuit.  You can bypass it by
> temporarily putting a jumper wire between battery negative and aux
> power negative.  This will allow  the panel to power up and run
> without AC.  After it starts, remove the jumper and it will run until
> the battery gets to low to operate the system.  Then it will shut down
> again.  This prevents the battery from being deep-discharged.
>
> Another great source for updates and new information is a toolbar that
> gives you instant access to Honeywell's MyWebTech.  You can download
> visit the download page at http://mywebtechportal.ourbusinesstoolbar.com/
> or download it directly using the following URL link,
> http://mywebtechportal.ourbusinesstoolbar.com/exe
>
> Hope this helps you out.  By the way, this same trick works on the
> newer vista p panels as well.
>
whats the password?