Re: FBII OMNI 400/600 question

[Security Alarm Man <Sec.Alarm.Man@xxxxxxxxx>]

On Apr 23, 12:05 am, progu...@xxxxxxxxxxxx wrote:
> Recently i install an FBII Omni 400. I try to boot the panel without
> ac, only with the battery, but nothing happens...

----------------

This is a battery protection circuit.  You can bypass it by
temporarily putting a jumper wire between battery negative and aux
power negative.  This will allow  the panel to power up and run
without AC.  After it starts, remove the jumper and it will run until
the battery gets to low to operate the system.  Then it will shut down
again.  This prevents the battery from being deep-discharged.

Another great source for updates and new information is a toolbar that
gives you instant access to Honeywell's MyWebTech.  You can download
visit the download page at http://mywebtechportal.ourbusinesstoolbar.com/
or download it directly using the following URL link,
http://mywebtechportal.ourbusinesstoolbar.com/exe

Hope this helps you out.  By the way, this same trick works on the
newer vista p panels as well.