[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Re: Check 70 Trouble
> Bell supervision trouble...check your
> siren/bell wiring...or just see if the
> siren/bell runs.
True. Also, if the red jumper has been
cut the gentleman will need a 1K-Ohm
EOL resistor across the siren terminals.
The factiry default (jumprt uncut) is an
unsupervised output.
Note to newbies: Do NOT install the EOL
resistor inside the panel. Place it at the
siren location.
--
Regards,
Robert L Bass
=============================>
Bass Home Electronics
941-925-8650
4883 Fallcrest Circle
Sarasota · Florida · 34233
http://www.bassburglaralarms.com
=============================>
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home