Re: 15 sec dialer delay

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

 I guess if you have an alarm panel that could be programmed to close/open a
relay upon a cancel you could do this...but otherwise  how would you do it?
How would you tell Uplink to send a cancel?


"Don" <don@xxxxxx> wrote in message
news:7VqKg.42872$e9.2882@xxxxxxxxxxxxxxxxxxxxxxxxx
|
| "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
| news:5KadncLD-42msWfZnZ2dnUVZ_q2dnZ2d@xxxxxxxxxxxxxx
| >
| > "Don" <don@xxxxxx> wrote in message
| > news:iMmKg.34288$C6.27547@xxxxxxxxxxxxxxxxxxxxxxxxx
| >>
| >> "Don" <don@xxxxxx> wrote in message
| >> news:4DmKg.34281$C6.7293@xxxxxxxxxxxxxxxxxxxxxxxxx
| >> >
| >> > "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
| >> > news:me-dneIX27ZSb2TZnZ2dnUVZ_oednZ2d@xxxxxxxxxxxxxx
| >> >>
| >> >> Put the uplink on an output trigger and delay that?
| >> >>
| >> >
| >> > don't see where I can delay an aux output on a NX8 but you got me
| > thinking
| >> > in a different direction.  How about using an aux output to trigger
on
| >> > code entry and define that in uplink as a cancel?  going to uplink
site
| >> > now to see if possible.  will report back. thanks.
| >>
| >> cancel is not an option in the uplink setup definitions.  so much for
| > false
| >> alarm reduction in the industry, huh?  Any Uplink guys reading this?
Add
| >> CANCEL to the setup for Anynet GSM.  Then give me a job in management
for
| >> coming up with this.;)
| >
| > explain exactly how they could possibly do this?
|
| add cancel to the list of definitions in the alarm setup.  whew, that was
| hard.
|
| >
| > Neither Uplink or GE can take into account every possibe combination
that
| > their products will be used for
|
| yea I guess you're right.  who needs a bleedin cancel signal anyway. and
| screw the constabulary, they are probably just eating donuts anyway,
right.
| a few false alarms are good exersize, heh.
|
|