Re: contact window/ most used tool

["Jim" <alarminex@xxxxxxx>]

Don wrote:
> "Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
> news:453d293a$0$610$815e3792@xxxxxxxxxxxxxxxxx
> > I'd try a supermagnet first, looks like you have room to tuck one up
> > beside
> > the seal.
>     egzackly what I ended up with.  3/8" switchs with terminals.  No way to
> drill up for mag.  Not enough room.  Those drawings must not have been
> scale.  1/8" flat mag with the dst fit nicely in bottom sash on the inside
> edge of the notch for the seal,  lined up perfect with hole drilled just
> inside barrier down thru sill  to basement.  Ended up not as bad as I
> imagined.

I knew it would work. There's nothing like being in the field and
actually
working on the job. Certainly better than sitting in an office in
Florida
reading a print copied off the Internet and then trying to tell someone
who's actually done the work, that they're wrong.


>     Found these today .  Havent seen them in years, so ordered a couple.
> This is the single most used hand tool that I have had in my hand in the
> last 5 years.  Cutter, stripper and real b connector crimper out at the end
> of the tool.  Good for rough and finish work.  Any others?