Re: House / Garage / 2 partitions setup question

[Bencrx91 <Bencrx91@xxxxxxxxxxx>]

Ok,

I guess the 2nd LCD in the house is the most simple and cheap($)
method to know what's happening in the garage.

Thanks again!
Ben


On Sat, 4 Mar 2006 19:10:23 -0700, "Crash Gordon"
<webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote:

>Generally partitioned systems act as two separate alarm systems and you
>can't display one partition on the other unless you install a keypad on the
>garage partition in the house. I say generally because I don't use DSC but I
>do use several other brand panel with partitions.
>
>
>"Bencrx91" <Bencrx91@xxxxxxxxxxx> wrote in message
>news:03fk02h82c7pskta9kq1rjbbs7gb912hvf@xxxxxxxxxx
>| Good day all, I have a question about my alarm setup.
>|
>| Current setup:
>|
>| I currently have 1 DSC main alarm panel with 8 zones (house) + 1
>| expander 8 zones (garage). [Garage is located in the backyard]
>|
>| The house and garage were setup as 2 separate partitions. (I can
>| activate 1 or the other independantly or both at the same time).
>|
>| I have a DSC LCD Display in the house and another one in the garage.
>|
>| My question:
>|
>| When the alarm is triggered in the garage the "zone triggered" is
>| being diplayed only on the LCD/Keyboard in the garage and not in the
>| house. (And vice-versa)
>|
>| Is there any way to have the "triggered zone" displayed on all
>| LCD/KEYBOARD *even* if the 2 keyboards are on two separate partition ?
>|
>| Example: if the alarm goes off in the garage I would like to see
>| "GARAGE" on the LCD in the house.
>|
>| Currently the horn goes on, but I have nothing displayed on the lcd
>| (house), when one of the garage zone is triggered.
>|
>| Is there any solution to that ?
>| Thanks,
>| Ben
>|
>