Re: DSC Power 632 DIY questions

["mikey" <loismustdie@xxxxxxxxx>]

What format are you using? I'd suggest CID, your pager will display 6
numbers, a 4 digit account code and 2 digit CID code. You have to program
the code you want the panel to send in zone section.
I use D and EEEB after the area code and number for my commercial pager.
Tedious to program by keypad... suck up to a dealer here to download it, are
you local to 613 741- (that's me)
Just change your installer code after the download.

<bjeff65@xxxxxxxxx> wrote in message
news:1141677027.618049.259600@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> I bought and wired up this kit from SmartHome:
>
> http://www.smarthome.com/7507kit.html
>
> The PC1555MX (AKA Power 632) seems to have the same programming as the
> DSC 5010 Power 832. I've spent quite a bit of time reading past posts
> in the newsgroup. However, I'm stuck on a handful of items:
>
> 1. The toughest one is getting panel feedback. While the keypad does
> give the binary value of the first digit when in programming mode, the
> emergency keys do not move to the next digit as the Installation manual
> states. So while I would love to give the actual panel data, I haven't
> found a way to retrieve it.
>
> 2. Stay mode doesn't work as advertised. I currently have 4 doors zoned
> as Delay 1 and one motion sensor as Interior. Stay mode does bypass the
> motion sensor. However, the doors are still on delay in Stay mode. How
> can I program the panel to give an instant alarm when a Delay 1 door is
> violated in Stay mode?
>
> 3. I wired the telephone jack using some instructions that Robert Bass
> posted in this newsgroup a while ago. The phone line seems to be
> properly hooked up because I'm no longer getting a fault for TLM once I
> reactivated it. I have had no luck in getting pager mode to work.
> Following a post here I programmed sections 160, 310, 310, 360, and 365
> with reasonable data. I also added the D before the telephone number
> and a handful of E's after. I'm working on a direct dial right now.
> According to the installation instructions, selecting *6<Master> then 4
> activates the alarm and all keypad indicators for 2 seconds, then is
> supposed to send a communications status via the telephone. The first
> two items occur as described. However, the phone never rings. I did
> program the system status code and a reasonable account number for the
> first telephone number.
>
> Any help with these items would be greatly appreciated. Also if there's
> a post in the newsgroup somewhere that I may have missed, a pointer to
> it would be welcome.
>
> Thanks,
>
> BAJ
>


*** Free account sponsored by SecureIX.com ***
*** Encrypt your Internet usage with a free VPN account from http://www.SecureIX.com ***