[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: DSC Power 832 - PC5501Z Keypad - Zone 1 Question

Subject: Re: DSC Power 832 - PC5501Z Keypad - Zone 1 Question
From: "J Barnes" <trishnjames@xxxxxxxxxxx>
Date: Mon, 5 Jun 2006 21:44:12 -0600
Newsgroups: alt.security.alarms
References: <lor982hmeg7h4tjk2a9pgh2gcd6fkps5ch@xxxxxxx>

A jumper or a Resistor?       Zone 1 works the same as the other zones.  Try
putting the resistor across zone one but make sure to disconnect the actual
zone wires from it.  This should narrow it down.

James


"Surebet" <surebet@xxxxxxxxxxx> wrote in message
news:lor982hmeg7h4tjk2a9pgh2gcd6fkps5ch@xxxxxxxxxx
> I've read the manual and have a question.  Is the wiring for zone 1
> different than the other zones?  All of my other zones work fine
> except for zone 1.  I know the contact is good and I have even
> replaced it on the panel with a jumper between ZN1 and COM and yet the
> system still sees zone 1 as open.  Any suggestions?
>
> -Russ

References:
- DSC Power 832 - PC5501Z Keypad - Zone 1 Question
  - From: Surebet

Prev by Message: Re: Suggestions for inexpensive security camera setup
Next by Message: Re: Customers
Previous by thread: Re: DSC Power 832 - PC5501Z Keypad - Zone 1 Question
Next by thread: Re: DSC Power 832 - PC5501Z Keypad - Zone 1 Question
Index(es):
- Message
- Thread

alt.security.alarms Main Index | alt.security.alarms Thread Index | alt.security.alarms Home | Archives Home