Re: Napco GEM-P1632 Easy Menu Mode

["Knight Houston" <d.cron@xxxxxxxxxxxxx>]

that was it ..... I did not pay attention to the wiring diagram !!!!




Bob La Londe wrote:
> Zone 7/8 is common/seven/eight not seven/common/eight like the other zones.
> Also, there are two jumpers on the board for seven eight which set them as
> either two wire fire or burg zones.
>
> They do not wire the same for fire as burg.  There is a wiring diagram on
> the door of the panel.
>
> Also, there should be address programming in the programming manual.
>
>
>
>
>
> "Knight Houston" <d.cron@xxxxxxxxxxxxx> wrote in message
> news:1152497984.259965.320410@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> >
> > Knight Houston wrote:
> >> Bob La Londe wrote:
> >> > "Knight Houston" <d.cron@xxxxxxxxxxxxx> wrote in message
> >> > news:1152484876.338649.167350@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> >> > >I am having trouble geting to the easy menu mode. On Page 47 of the
> >> > > install manual it shows the easy menu mode. I am trying to access the
> >> > > area of "# of zns in Area!1*"
> >> >
> >> > A lot of stuff is only accessible the first time you enter the easy
> >> > menu.
> >> > After that you have to go to address programming or use the PCD
> >> > software.
> >> >
> >> >
> >> > --
> >> > Bob La Londe
> >> > Fishing Arizona & The Colorado River
> >> > Fishing Forums & Contests
> >> > http://www.YumaBassMan.com
> >> >
> >> >
> >> >
> >> > --
> >> > Posted via a free Usenet account from http://www.teranews.com
> >>
> >> is there a address guide ?
> >
> > I am also have a fault in zone 8 with a resistor in line. when I hook
> > up common for 7 and 8 I get a fault in both zones .... not
> > understanding... is there a factory reset button?
> >
>
>
>
> --
> Posted via a free Usenet account from http://www.teranews.com