Re: GE Concord

[Sean Sokoly <alarmdude01@xxxxxxxxx>]

J Barnes wrote:
> Thats what I did, I set up zone 1 and 8 for entry exit. and zone 2,3,4 for
> interior zones. 5,6,7 are perimeter but when I run a test the central only
> gets an alarm 850 with no zone numbers. :(
>
> James
>
>
> "Sean Sokoly" <alarmdude01@xxxxxxxxx> wrote in message
> news:ZTJJf.1439$u54.336@xxxxxxxxxxx
>> J Barnes wrote:
>>> I installed my first GE panel today.  I was not able to get the zones to
>>> report to the CS though.  It would only send an alarm on zone 850.  I was
>>> trying to send alarms on zones 1-5.  I am using contact ID.  Is there a
>>> place to put the report codes in for the zones?
>>>
>>> James
>> What sensor group did you assign to zones 1-5? There is no way to assign
>> report codes. The sensor group assigns a CID Event Code or SIA event code
>> that pertains to the sensor group that is selected in learn zones. IE Zone
>> 1 Might be basement windows etc you assign Sensor Group 13 (Perimeter
>> Burglary) to it under the Sensors Menu it would then report a
>> 130 CID Burg Event then the zone.
>>
>> Sean
>
>
odd never had that happen. Is your central station capable of receiving
SIA? you might want to try SIA and see what happens.

Sean