Re: CCTV mount

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

I am emt bender challenged. A few years ago I was running some on the
exterior of my house for Cat5, while my daughter...abt 10 at the time
watched. Dad you're doing it wrong...whaddya mean?...I'm not doing it wrong,
besides what do YOU know. Shit that went on at least 5 times as I continued
to bend in the wrong direction. :-)

Anyway, I'm thinking I "may" just get a way with a straight arm except it's
not high enough..someone tall could probably reach it. The prospective
client volunteered to install a tall pole too....that may be better.

tnx.

"Bob Worthy" <securinc@xxxxxxxxxxxxx> wrote in message
news:rWA2f.9619$5l.8966@xxxxxxxxxxxxxxxxxxxxxxxxx
|I try to stick with store bought but some stuff like that is hard to find,
| if at all. We make some of this stuff ourselves out of 3/4 inch conduit, a
| male adaptor, a blank plate with threaded knockouts (these come with
gaskets
| for exterior use),  a couple of 90 degree bends, a small screw (stainless)
| to match the camera mounting hole and a nut (stainless), some Rust-o-lium
| primer and a color to match the exterior of the building and it is as good
| as a store bought and less expensive. It really helps when the application
| doesn't require exact 90's like you will get from the factory. You can get
| pretty creative if your good with a pipe bender, especially if you need
| something that must stay tight to the building.
|
| "Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
| news:ycA2f.42$vV4.884@xxxxxxxxxxxxxxxxxx
| > I need an odd camera mount for exterior mount. Lightweight camera. Needs
| to
| > be like an L mount to mount on side of building and come out abt 18 or
so
| > inches to clear the overhang then go up abt the same distance
| (measurements
| > not critical at this time). Trying to avoid a custom build.
| >
| > Anyone know a source?
| >
| > TNX
| >
| >
|
|
|