Re: DMP Hoovers

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

"Bob La Londe" <usenet@xxxxxxxxxxxxxxxx> wrote in message
news:yq-dnYnsUtmY9aDeRVn-ig@xxxxxxxxxxxxxxx
> Ok, this is number 4 or 5.
>
> The manual says,
>
> 1.  Place a slotted screwdriver across the two J16 reset jumpers for two
> seconds.
> 2.  Remove screwdriver.
> 3.  Enter the code 6653 (PROG) at the keypad.
> 4.  Enter Access Code (if prompted to do so).
> 5.  The keypad displays: PROGRAMMER.
>
> Ok..
>
> I hit the J16 jumper, walk over to the keypad, and it no longer responds.
> After a while it comes up as system busy, then after a while longer it
says
> system trouble.  I do the voltage check as the tech support people suggest
> and get the 5 volts on both sets of leads that indicate the processor is
> locked up.
>
> These panels are permanently locking up from trying to put them in program
> mode.  And YES!  They were functioning properly before attempting to put
> them program mode.

Thats a strange one, I haven't yet run into that although I rarely do DMP