Re: Ademco 4110 Engineer manual question

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

Must be a different version than we have here. A 4110 Ademco panel is really
old and never had a header for siren output module...at least that I can
remember...in fact I don't think any of the Vista's do either.

Regardless, if its connected correctly there should be no voltage output
unless something is in alarm...do you have any zones programmed as fire or
manual panic buttons? If you do, normalize them and see if the siren stops.


"SantaUK" <santa@xxxxxxxxxx> wrote in message
news:434fec45$0$1592$c3e8da3@xxxxxxxxxxxxxxxxxxxx
| There is, well on the Vista's which I believe are the same panels.  Its
the
| menu option number I am looking for, as soon as I connect the cable the
| sounder constantly activates, no matter in the set or unset mode.
|
| And the sound module is fitted straight onto the pins on the main board,
and
| can't be connected wrongly.  Do you have the manual by any chance?
|
| --
| Regards
|
|
| M Millar
|
| "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
| news:JIadncS_xvl3YtfeRVn-oA@xxxxxxxxxxxxxx
| >
| > "Michael Millar" <santa@xxxxxxxxx> wrote in message
| > news:iIKdnVFwFfFaO9fenZ2dnUVZ8qSdnZ2d@xxxxxxxxxxxx
| >> Hi
| >>
| >> I need to install a 4110SM (Speaker Module) onto a 4110 panel.
Everytime
| > I
| >> connect the speaker it sounds straight away, I am sure it is programmed
| > for
| >> latching the terminal SW1 negative for the power supply.
| >>
| >> I'm looking for which code in the programming menu it is to change to
| > allow
| >> the speaker module to be attached.
| >>
| >> If anyone has the manual (specifically for the 4110) I would appreciate
| >> it
| >> too.
| >
| > There is no "code". Either you have a zone in alarm or you've wired it
to
| > the wrong terminals
| >
| >
|
|
|