Re: Adding Ademco 5804BD

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

Add a user code to user 30 (example)

Master code + 8 + 30 + # + 4 + 1st keyfob zone programmed into the panel

"Peter Wells" <rth864@xxxxxxxxx> wrote in message
news:_Dlhe.64298$AE6.5369@xxxxxxxxxxxxxxxxxxxxxxx
> The panel is a 20P.  What is the "code" that I need to asign, it already
has
> the house id.
>
> thanks,
>
> Peter
> "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
> news:0IqdnWcIxYGG_hjfRVn-1Q@xxxxxxxxxxxxxx
> > Not on a Vista-20, if it was a 20P then you would be correct
> >
> > "Crash Gordon®" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
> > news:XH9he.39$H85.1266@xxxxxxxxxxxxxxxxxx
> > If I remember correctly you have to assign a code for the 5804 to work.
> >
> >
> > "Peter Wells" <rth864@xxxxxxxxx> wrote in message
> > news:PD7he.63982$AE6.1630@xxxxxxxxxxxxxxxxxxxxxxx
> > > I'm having trouble adding a 5804BD to my home system (Vista 20).  I
> > > installed the 5800TM and programmed the House ID into both the panel
and
> > the
> > > remote - this seemed to work fine and the unit gives me a good status.
> > Then
> > > from inside Ademco's Compass software I added two zones with the loops
> > info
> > > and remote wireless ID for the A & B buttons, one to arm-away and the
> > other
> > > to disarm.  The panel took the commands but pressing the buttons
doesn't
> > > operate the panel.
> > >
> > > Any ideas?
> > >
> > > Thanks in advance,
> > >
> > > Peter
> > >
> > >
> > >
> > >
> > >
> >
> >
>
>