Re: Adding Ademco 5804BD

[Crash Gordon® <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

You have to assign a user code.

Let's say your 4 button RF key is at Zones 49/50/51/52 and User Number =
is user 30, you just have to make sure you have a user code 30.

If you're using Compass look in Zones to see your RF button, then in =
Users you can add the code and at the bottom under RF information..the =
RF Key drop-down. You only need one code set.



"Peter Wells" <rth864@xxxxxxxxx> wrote in message =
news:_Dlhe.64298$AE6.5369@xxxxxxxxxxxxxxxxxxxxxxx
> The panel is a 20P.  What is the "code" that I need to asign, it =
already has
> the house id.
>=20
> thanks,
>=20
> Peter
> "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
> news:0IqdnWcIxYGG_hjfRVn-1Q@xxxxxxxxxxxxxx
> > Not on a Vista-20, if it was a 20P then you would be correct
> >
> > "Crash Gordon=AE" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
> > news:XH9he.39$H85.1266@xxxxxxxxxxxxxxxxxx
> > If I remember correctly you have to assign a code for the 5804 to =
work.
> >
> >
> > "Peter Wells" <rth864@xxxxxxxxx> wrote in message
> > news:PD7he.63982$AE6.1630@xxxxxxxxxxxxxxxxxxxxxxx
> > > I'm having trouble adding a 5804BD to my home system (Vista 20).  =
I
> > > installed the 5800TM and programmed the House ID into both the =
panel and
> > the
> > > remote - this seemed to work fine and the unit gives me a good =
status.
> > Then
> > > from inside Ademco's Compass software I added two zones with the =
loops
> > info
> > > and remote wireless ID for the A & B buttons, one to arm-away and =
the
> > other
> > > to disarm.  The panel took the commands but pressing the buttons =
doesn't
> > > operate the panel.
> > >
> > > Any ideas?
> > >
> > > Thanks in advance,
> > >
> > > Peter
> > >
> > >
> > >
> > >
> > >
> >
> >
>=20
>