Re: napco cancel code

[Don <Don@xxxxxx>]

robertlbass@xxxxxxxxxxx wrote:
> You can program it so send an "opening" signal and set that to only be
> sent if the panel has had an alarm activated.  To do this set up
> Opening reports in the usual fashion.   On the "User Assignment" screen
> select the "User Reporting Open/Close" tab and place a check mark in
> the appropriate receiver column for each user. Then, on the "Digital
> Communications" screen select the "Digital/Dialing Options" tab.  Place
> a check mark in the box labeled, "Opening Report only after alarm
> report."

this is what I was thinking about but am not that up on the napco stuff.
  thanks for the tip.  love that error check in the software.
so now I tell the CS to not call if opening reveived after alarm report?
    sounds a bit confusing, hope they can handle it.