Re: Caddx NX8E Aux Outputs

["ABLE1" <able1delete@xxxxxxxxxxxxxxxxxx>]

Try a jumper on J12.  Be careful Aux Outputs are Limited to 250 microamps
for positive and 50ma for negative sink.  Usually will need a low current
draw slave relay to drive something bigger than an LED.  Good Luck.

Les


"CatMan" <catman2k@xxxxxxxxxxx> wrote in message
news:EICdnZVYY9aK-MTfRVn-1g@xxxxxxxxxxxxxx
> I have been trying to program my Aux 1 output to follow the panel's
> Armed state. I using the DL900 software I have Aux 1 set to type 21 and
> the timer set to 0. According to the docs this should cause the Aux 1
> output to follow the Armed state fo the panel. Of course this doesn't
work.
>
> I also tried the latched and not latched settings and received the same
> results with both. Now, on my panel there is a screw terminal strip
> where the power, bell, wireless, keypad, and internal wired zones
> connect to.
>
> On the bottom of the terminal strip are five screws labeled:
>
> Aux 2 C
>
> Aux 2 NO
>
> Common
>
> Aux 1 NO
>
> Aux 1 C
>
>
> I have 12VDC on all of them referenced to the Common except for the Aux
> 1 NO. It is 0 Volts regardless of the panel?s armed state or of the
> ?Latched? selection in the configuration.
>
> Maybe someone will chime in here that knows how to configure these Aux
> outputs. If you look in the docs for the panel I can see a lot of
> possibilities with the Aux outputs.
>
>
> Thank you again for your help!