Re: Gardtec 800 Series Error Code?

[adam.cruickshank@xxxxxxxxx (Adam Cruickshank)]

"Paul \( Skiing8 \)" <skiing@xxxxxxxxxx> wrote in message news:<d40bhn$aoc$1$830fa7a5@xxxxxxxxxxxxxxxx>...
> "Adam Cruickshank" <adam.cruickshank@xxxxxxxxx> wrote in message
> news:75fb76b0.0504180243.6cdf7240@xxxxxxxxxxxxxxxxxxxxx
> > "Paul Ekins" <123pmekins@xxxxxxxxxxxxxxxxxxx> wrote in message
> news:<kwz5e.10407$JO6.2848@xxxxxxxxxxxxxxxxxxxx>...
> > > Sounds like zone 1 tamper to me.
> >
> > Sorry for the very late reply.  I posted this and forgot all about it
> > today.
> > Thanks both of you for your answers.
> >
> > Assuming it's zone 1 tamper, is there anything I can do to the system
> > to sort it and get the alarm arming itself?
> >
> > Cheers
>
> I just looked at the user document and I don't think you can turn off a
> tamper zone while you are setting the alarm. The tamper zone is usually a
> loop that runs around all the alarm sensors, if the loop is broken anywhere
> then you get that t1 code. I will try tonight and see if I can enable the
> alarm with a tamper zone error. If you know a little about alarms then you
> can temporarly disable the tamper zone be opening the main panel and putting
> a jumper between the tamper zone terminals.
>
> When you open the main panel you will need to enter the code on the keypad
> to avoid setting off the alarm.
>
> Paul

Thanks again.

It sounds like it's getting beyond my capabilities and I'll just have
to get somebody out to look at it.