Re: Caddx Hardwired to Wireless Sensor

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

"Veloman" <velomanhere@xxxxxxxxxxx> wrote in message
news:1113058634.692370.57960@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> I need to connect a Sentrol barrier bar on a basement window.
> Unfortunately, due to its location running a hardwired connection from
> the barrier bar to the panel is not possible.
>
> I was considering using the NX-650 sensor with the 8E panel.   The 650
> sensor is a window/door sensor which has a terminal strip for an
> external hardwired connection.   After getting the sensor I determined
> that the hardwired connection on this sensor is NO while the barrier
> bar requires a NC connection.  Does anyone have any ideas on how I can
> connected a barrier bar using wireless to a CADDX panel?   Or how I can
> convert a NC contact to NO with an external circuit?
>
> Thanks

You can go into the NX448 wireless receiver programming and set that
contact's options as either N/O or N/C