Re: T.O.M 10 info to HV

[steve.cooper@xxxxxxxxxxxxx]

>> I cannot see how to pass the temps from T.O.M 10  to HV
> Cant see how this could be done at the moment ,as hv variables are 1
byte
> and the xPL globals vary in size and the temp globals would be 4 bytes
> ....In my setup i just store the temps in xPL  Globals so hasnt been a
> problem...not sure if  Steve can do something about this.....

As Frank says not sure how you would load something like 19.6 into a
variable that can have a value 0 to 255.

> I think the temps  are converted in Justins board to C......Might be
> possible for Steve to add in the tom10 config a tick box to enable F
> conversion ????

This is possible from a code point of view but I believe that there is a
xPL standard that say all temperatures will be reported in C to avoid
confusion.  Not sure whether this is documented but it was certainly the
case from the beginning IIRC.

S.




___________________________________________________________________________
Authorised and regulated by the Financial Services Authority
___________________________________________________________________________
The information contained in this message is confidential and may be
legally privileged. If you are not the intended recipient, please do not
read, copy or otherwise use it and do not disclose it to anyone else.
Please notify the sender of the delivery error and then delete the
message from your system.
Any views or opinions expressed in this email are those of the author only.
Communications will be monitored regularly to improve our service and for
security and regulatory purposes.
Thank you for your assistance.
___________________________________________________________________________



xPL Links: http://www.xplproject.org.uk http://www.xplhal.com http://www.xpl.myby.co.uk
To Post a Message: ukha_xpl@xxxxxxx
To Subscribe:  ukha_xpl-subscribe@xxxxxxx
To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx