The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: xPL cm11 Service


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: X10 Schema and Preset Dim



I suppose you would normally put that in the "level" field ?
I.e.:
command=predim1
device=A1,B7,G2
level=10

The medusa component ignores the level field for predim1 and predim2.
If you (or somebody else) acknowledge that a "predim" command is
always used in combination with a "level" then I will add that to
the
code.  (Minor change)

Tom


On 12/13/05, Eric Vickery <ericvic@xxxxxxx> wrote:
> For anyone that is using the X10 schema and PREDIM1 or PREDIM2 where
are
> you putting the dim level?
>
> Eric
>
>
> xPL Links: http://www.xplproject.org.uk http://www.xplhal.com
> http://www.xpl.myby.co.uk
> To Post a Message: ukha_xpl@xxxxxxx
> To Subscribe:  ukha_xpl-subscribe@xxxxxxx
> To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx
>
>
> ________________________________
> YAHOO! GROUPS LINKS
>
>  Visit your group "ukha_xpl" on the web.
>
>  To unsubscribe from this group, send an email to:
>  ukha_xpl-unsubscribe@xxxxxxx
>
>  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
>  To unsubscribe from this group, send an email to:
>  ukha_xpl-unsubscribe@xxxxxxx
>
>  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
>  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
> ________________________________
>



xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.