The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Could use some help with the HomeVision Plug In


  • Subject: Could use some help with the HomeVision Plug In
  • From: "gmotichka" <gmotichka@xxxxxxxxxxxxx>
  • Date: Fri, 03 Dec 2004 23:12:45 -0000



I am a total newbie at this. With help from the folks here I do have
xPLmanager running and xPLw800 running.

The main reason for getting the w800 was to eliminate all the
individual receivers for x10. It must also interact with HomeVision
since I use some x10 code to kick off macros. That it what I am
trying to get going here.

I have the HVInput.hvx and HVExclue.hvx files. I also have the plug
in installed. I did read the doc file that came with the plug in,
but I did not find it real clear (obviously from my general
ignorance of this project).

I do not want to get into a lot of duplicate programing - i.e.
repeating programing I already have in HV. A couple main funtions
would serve me well. One being to pass on an x10 signal received
from the w800 to HV to execute, and when an x10 signal is received
that is associated with a macro in HV to run it.

Once I get that running I will be able to play around with other
posibilities, especially if I run the plug in in debug mode to
follow what it happening..

Thanks
George M






xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.