Re: Communicatiing with xplHal

["Frank Mc Alinden" <fmcalind@xxxxxxxxxxxxxx>]

> 3) When this configuration stuff is working, I'll need a vendor Id
> before I can release the app - where do I get that from?

You put in a request here and usually Ian Okays it !!!....

Frank

----- Original Message -----
From: "Mal Lansell" <mlansell@xxxxxxx>
To: <ukha_xpl@xxxxxxx>
Sent: Tuesday, August 31, 2004 7:06 PM
Subject: [ukha_xpl] Communicatiing with xplHal


>
> I'm almost finished writing a service to xpl-enable the WGL Designs'
X10
> rf receiver - messages are picked up by xplHal just fine, but now I
want
> to get the configuration side of things working.
>
> I send a config.app message that is received OK (I can see my device
in
> the xplManager, awaiting configuration), and from the xplMonitor I can
> see that a config.current and config.list request is sent in return.
> However, I'm not receiving these.  This is the first time I've written
> anything using sockets, so I have a couple of questions before I waste
> too much time blindly debugging...
>
> 1) Does xplHal return the config.current and config.list using the
same
> connection that I use to send the config.app, or should I listen for a
> connection on the port supplied in the config.app?
>
> 2) Do you connect to xplHal everytime you need to send something, or
do
> you connect once and keep the connection open?
>
> 3) When this configuration stuff is working, I'll need a vendor Id
> before I can release the app - where do I get that from?
>
> Cheers
>
> Mal
>
>
>
>
>
> xPL Links: http://www.xplproject.org.uk http://www.xplhal.com
http://www.xpl.myby.co.uk
> To Post a Message: ukha_xpl@xxxxxxx
> To Subscribe:  ukha_xpl-subscribe@xxxxxxx
> To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx
> Yahoo! Groups Links
>
>
>
>
>
>
>