Re: Re: xPLHal Win 98 problems, does this help?

[steve.cooper@xxxx]

> On loading xPLLaunch.exe Lots of messages, that I think are correct,
> UNTIL "Sending Hello" then Err126

This is fine

> xPL Icon added near clock
> Last message is "ready for config" wish I assume is correct

If you got here this means that the application is ready and loaded. It
should appear in either xpl_devices or the awaiting configuration section
of xplhal manager (may need to right click on the sections and refresh).

try adding the following routine to your GB.xpl script

sub launch_config()

strmsg="interval=5"+chr(10)
call
xpl.sendmsg("","TONYT-LAUNCH.GARY","config.response",strmsg)

end sub

Save and reload scripts.

Run sub-routine launch_config first then sub-routine notepad. The above
script is essentially does the config for you instead of doing it xplhal.

S.



___________________________________________________________________________
The information contained in this message is confidential and may be
legally privileged. If you are not the intended recipient, please do not
read, copy or otherwise use it and do not disclose it to anyone else.
Please notify the sender of the delivery error and then delete the
message from your system.
Any views or opinions expressed in this email are those of the author only.
Communications will be monitored regularly to improve our service and for
security and regulatory purposes.
Thank you for your assistance.
___________________________________________________________________________