I need to cleanly cut mitres in some 4" x 2" rectangular profile
trunking and was wondering if anyone knows whether it's possible to use hot
wire cutters to get a nice clean and square cut or am I stuck with using my
old 18TPI mitre saw which doesn't do that good a job on the relatively
floppy box section of the trunking...
Phil
Sent from another bloody fruit-based portable device...
------------------------------------
<*> Join the Automated Home Forums
http://www.automatedhome.co.uk/vbulletin/
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.