A chop saw with a decent high TPI blade would do the trick.
Especially if you cut it with the lid on?
Tracey
>
> I need to cleanly cut mitres in some 4" x 2" rectangular
profile trunking
> and was wondering if anyone knows whether it's possible to use hot
wire
> cutters to get a nice clean and square cut or am I stuck with using my
old
> 18TPI mitre saw which doesn't do that good a job on the relatively
floppy
> box section of the trunking...
>
> Phil
>
------------------------------------
<*> Join the Automated Home Forums
http://www.automatedhome.co.uk/vbulletin/
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.