The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: Re: Fuse has blown inmy Pioneer plasma PSU



I believe this is the known PSU problem with Pioneer units my 434
failed
exactly the same and it was replaced FOC well out of warranty.

Pioneer support are not very forthcoming - ring them up ask for a local
repairer - my repairer immediately confirmed it was FOC replacement.

Do a Google for Pioneer Plasma problems - its bound to come up.



Dean.



-----Original Message-----
From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
darren_karp2001
Sent: 22 November 2007 14:30
To: ukha_d@xxxxxxx
Subject: [ukha_d] Re: Fuse has blown inmy Pioneer plasma PSU

--- In ukha_d@xxxxxxx, "Slavo" <slavo@...> wrote:
>
> Darren,
>
> you need to replace the fuse with one that has the same current
> characteristics. Inrush current is what you get when you switch
some
> appliances on. Current can be several times the rated amount (but only
> for short period) so if you replaced it with ordinary one you may blow
> it again first time you switch it on. The current curve
for
> your fuse is defined here.
>
> http://www.socfuse.co.jp/SOCcatalogE/Page45.pdf
>
> Slavo
>
Thanks.

I spoke with their European headoffice today and a very nice chap managed
to
find me an RS part which I fitted.

Now the problem is although the plasma goes into standby which it didn't
yesterday when I switch it on the power led goes green and 3 or so seconds
later I hear a relay click and goes back into standby.

So, what I need now is an electronics engineer that can test the PSU board.

Any offers?

Cheers
Darren










UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.