RE: CBUS assistance

["Mike Griffiths" <mike@xxxxxxxxxxxx>]

Hi Adrian
You can only have a dimmer set to one group, though you can have more
than one dimmer set to the same group
You either control the dimmer directly or via scenes or Logic (PAC etc)
You can set up a simple switch to control more than one group
More expensive switches have scenes built in.

Hope this helps
Mike


-----Original Message-----
From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf
Of Adrian
Sent: Tue 14 November 2006 10:12
To: ukha_d@xxxxxxx
Subject: [ukha_d] CBUS assistance

Hi

trying to get this to work with no success

I have 2 groups setup for 2 channels on a dimmer unit (say group 1 and
group 2)

these are controlled fine by a switch (switch 1 dimmer for group 1,
switch 2 dimmer for group 2)

What i'm trying to configure is a separate switch elsewhere which will
either turn both these lights off or on.

I configured on the dimmer a new group which had group 1 and group 2
selected (call it group 3)

now when I configure a button for on/off , i get some very different
results.
if both group 1 & 2 are off or on, it all works fine, i can turn both
lights on/off via group3
where it stuffs up is if say group 1 is on, it then turns on group 2 ok
but when turning off, it only turns off group 2 and leaves group 1 on

Am i missing something, is this possible?

Adrian





** Sponsored by http://www.BERBLE.com **
all the Cool Stuff, in one Place







______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please visit http://www.messagelabs.com/email
______________________________________________________________________




** Sponsored by http://www.BERBLE.com **
all the Cool Stuff, in one Place