The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: What Multimeter? General HA Use


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Conservatory planning


  • Subject: Re: Conservatory planning
  • From: "David Chapman" <david@xxxxxxxxxx>
  • Date: Wed, 11 Jan 2006 23:48:18 -0000
  • References: <1137014266.6076.4047.m27@yahoogroups.com>

> square metre is the give away - those around 75w/sq metre are really
for
> comfort use. 120w/sq.m upwards and you are getting upto the levels
needed
> for room heating.

Not the case for a new house - or an old house with good insulation. I'm
just finishing a renovation and it's been insulated well but construction
is
bog standard 75mm cavity brick and block walls (although have had
insulation
pumped in).

The water based underfloor heating system is designed around an output of
75w/sq.m (pipes under chipboard - not screed) and that is proving more than
adequate to keep us warm.  (20+ inside, freezing outside)

By the way - if you put any form of permanent heating in a conservatory it
will need building regs approval - if it's not heated and seperated from
the
house by a door then normally it doesn't need approval but check all this
carefully -  definitely don't "wing" it or it will likely come
back and bite
yer bum when you sell !!

David C




UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.