[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
RE: HELP!!! Cyrus 6 Amp ;o(
Hi Keith,
Not good at all .
I wonder if the previous amp - the one that has been replaced due to the
same flashy red light, caused the speaker to fry.
Thanks for your advice/thoughts, I'm going to have a chat with my mate
and inform him of said news.
Regards
Jonathan.
-----Original Message-----
From: Keith Doxey [mailto:ukha@xxxxxxx]
Sent: 25 October 2004 18:35
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] HELP!!! Cyrus 6 Amp ;o(
Hi Jonathon
> After checking all the connections, I plugged the speakers into my
other
> hifi and by the sound of it, the bass/mid speaker has blown (gently
> pushing the speaker in a little to check movement and the coil it
> grating)
>
Doesnt sound good :-(
The grating will be the voice coil rubbing on the magnet assembly. The
reason for the grating is that the voice coil has been fried either by
being
overdriven for long periods of time or by catastophic failure of the
amplifier causing it to dump the DC power supply into the speaker.
This causes the enamel on the windings to bubble up due to excessive
heat,
filling the air gap between the coil and the magnet. Eventually the
voice
coil either goes open circuit or totally short circuit.
> If I have all disconnected the light still flashes red.
>
That sounds like some sort of protection circuitry is activated but if
the
amp does have DC protection then I dont know why it didnt protect the
speaker in the first place :-(
Regards
Keith
UKHA_D Main Index |
UKHA_D Thread Index |
UKHA_D Home |
Archives Home
|