Re: Help wanted in terminology with 19" rack kit

["big_red_frog" <anthony.tod@xxxxxxxxxxxx>]

hi There,

Those will help to make the rack mount inside my cabinet, but what I
specifically require is something to do the role of the tie down bar
that was attached to the first patch panel I purchased. The other
patch panel, and most of those I see on ebay simply don't have this,
or a method for attaching similar.

Please see photo at

http://us.f1.yahoofs.com/groups/g_1109639/Big_Red_Frog/__tn_Patch+Pane
l+Tie+down+bar.jpg?

Thats in the photo section under Big_Red_Frog

I have no edit tool with me while I am abroad so that file is big, I
will remove it in the near future once I have resolved this issue!

All comment welcome, I think I am just being dull!

--- In ukha_d@xxxxxxx, "Neil Ball" <neilball@b...> wrote:
> Have you tried Netshop?
>
> 19" mounting angles & cable management
> http://www.netshop.co.uk/cabinets-and-enclosures-cable-
management.htm
>
> It's what I'm intending to use to fabricate my "rack" as it
will be
a hybrid
> unit built into the under-stairs cupboard.
>
> Regards
>
> Neil B.
>
> -----Original Message-----
> From: big_red_frog [mailto:anthony.tod@m...]
> Sent: Sunday, May 09, 2004 18:42
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] Help wanted in terminology with 19" rack kit
>
>
> Hi All,
>
> Now I am into the house we just built I am joining up all that
> cabling I lay in over the course of the last two years.
>
> Now this isn't an area I have worked in before.
>
> I bought two 19" 24port patch panels from ebay for the purpose.
>
> 1 had an armature on the back which you could tie wrap the cat5
cable
> to after you punched down. This has worked wonderfully, and I now
> have half my cabling sorted.
>
> however, the second panel has not armature and I can't just punch
> down the cable and let it hang off the back!
>
> What is this armature called, and is there some standard part I can
> get that goes onto the 19 inch rack mount kit that I can tie down
to?
>
> Also I am mounting these panels into a large cabinet that is
already
> installed, but it is not a 19 inch specific case, it is larger, and
I
> have some mains kit in this one as well, as other bits and pieces,
> therefore I need some 19 inch rack that I can mount onto the back
> panel, and will hold the panels far enought forward to allow the
> cables to drop nicely behind.
>
> Probably not described that to well, but does anyone have any ideas
> if what I need exists?
>
>
>
> [Non-text portions of this message have been removed]